Przeskocz do nawigacji głównej Przeskocz do wyszukiwania Przeskocz do głównej treści

COMPARATIVE ASSESSMENT OF LINEAR AND NONLINEAR FINITE-ELEMENT MODELS OF A SPLIT GEAR WITH A HYPERELASTIC INSERT AND IDEALIZED LATERAL RESTRAINT

Wyniki badań: Wkład do czasopisma › Artykuł › recenzja

Abstrakt

Summary. This study compares three finite element models of a split gear with a rubber insert, developed on the basis of the design described in Polish patent PL 244312 B1. The analyzed formulations comprised a large-deformation hyperelastic model, a large-deformation model with a linear elastic insert, and a small-deformation linear elastic model. A second-order Ogden model was used in the hyperelastic formulation. Three rubber compounds, M047, M067, and M058, were considered under two boundary-condition variants: free lateral deformation and idealized lateral restraint. At the maximum load case Q4, lateral restraint reduced the total displacement predicted by the hyperelastic model by 33.9–38.3%, depending on the rubber compound. Under the same constrained conditions, the large-deformation model with a linear elastic insert overpredicted displacement by 10.6–15.7% relative to the hyperelastic model, whereas the small-deformation linear elastic model produced deviations of 244.4–276.3%. The maximum von Mises equivalent stresses in the steel components were considerably less sensitive to lateral restraint then calculated displacements, with changes of approximately 1.1–2.7% in the hyperelastic model. The results indicate that the selection of the constitutive model, the inclusion of large deformations, and the representation of kinematic constraints are important in the analysis of nearly incompressible elastomers. The reported values represent relative deviations between numerical models rather than experimentally validated errors.

Język oryginałuangielski
Strony (od–do)107-119
Liczba stron13
CzasopismoTransport Problems
Tom21
Numer wydania3
Identyfikatory DOI
Status publikacjiOpublikowano - 2026

Obszary tematyczne ASJC Scopus

  • Inżynieria motoryzacyjna
  • Transport
  • Inżynieria mechaniczna

Fingerprint

Zanurz się w tematy badawcze publikacji „COMPARATIVE ASSESSMENT OF LINEAR AND NONLINEAR FINITE-ELEMENT MODELS OF A SPLIT GEAR WITH A HYPERELASTIC INSERT AND IDEALIZED LATERAL RESTRAINT”. Razem tworzą niepowtarzalny odcisk palca.

Cytowanie